Check with current HWiNFO32 what rates do you have and how would you like to change the logic (like - change step 4. I can offer to make a simple change to the table, so now the question: what kind of problems are you experiencing with the default fan control logic ? As I have been told, it seems that the fans begin too late to spin faster (temperature too high already) ? If this is the case I could change a single entry in the table to force a higher spin rate at lower temperature. The resulting fan RPM values are not exact and it seems that when trying to force the fan > 3500 RPM it won't rotate faster. Note that the temperature values are not in Celsius as I already mentioned, but in duty cycles of a PWM pin input. So after checking a dump from 8740w, the pre-defined look-up table looks like this: Now I want to do the same thing on Windows. I can also reset it back to automatic by echoing -1. I can do this on Linux via echo <0 to 255> /sys/class/hwmon/hwmon2/pwm1.And this is something I don't want to be responsible for. Ask Question Asked 3 years, 2 months ago Modified 3 months ago Viewed 21k times 4 I simply want to set my fan speed constant with a value from 0 to 100 (or the equivalent). I can think about adding some simple option to fix an issue, but giving the users too much control over the Temperature/Fan LUT (Look-Up Table) would be a bit complicated to implement and if not properly configured could cause damage. No, its not possible, since after power-on the fan controller is reset to its default state and the BIOS overrides the values each time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |